OO-A-373D
4.2 Quality conformance inspection. The quality conformance inspection shall include the examination of 4.3 and the tests of 4.4.
4.3 Examination. Each unit shall be examined for compliance with the requirements specified in section 3 of this document. Any redesign or modification of the contractor's standard product to comply with specified requirements, or any necessary redesign or modification following failure to meet specified requirements shall receive particular attention for adequacy and suitability. This element of inspection shall encompass all visual examinations and dimensional measurements. Noncompliance with any specified requirements or presence of one or more defects preventing or lessening maximum efficiency shall constitute cause for rejection.
4.3.1 Standards compliance. The contractor shall make available to the contracting officer or his authorized representative evidence of compliance with the applicable standard(s) specified in 3.5. The Government reserves the right to examine and test all units to determine the validity of the certification.
4.4 Tests. The contractor shall have an established test system which shall ensure compliance with the requirements of the specification and of the referenced standards. The system shall include the methods, procedures, controls, records, and maintenance of the system to provide verification of compliance with the requirements of this specification and of the referenced standards. For units less than 135,000 Btu/hr (39 565 W), the test shall have been mutually accepted between the contractor and the standards organizations.
5. PACKAGING
5.1 Packaging requirements. The preservation, packing, and marking shall be as specified in the contract or order.
6. NOTES
(This section contains information of a general explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The units covered by this specification are single package type designed for a large office space or space consisting of several rooms with cooling capacity range from 1 ton to
75 tons. A general guide to selection of types and classes are as follows:
6.1.1 Type SP-A. Type SP-A units are generally specified where condenser cooling water and drain facilities are not available.
6.1.2 Type SP-W. Type SP-W units can be used in areas where there is a cooling tower or readily available water supply and drain facilities.
6.1.3 Type SPY-A. Type SPY-A units can be specified when heating of the office space to be conditioned is required. Where no water, gas, electricity or steam is available for heating, the
15
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business